Fits Offenhauser 3x2 intakes for early overhead valve engines, like Ford Y-block and '49-'61 Cadillac, but check carb spacing before ordering
Use for 3x2 intakes with 4-3/4in carb spacing like Edelbrock 5412 for small block Ford and some Weiand intakes
For a chrome version, order 9246S-CHR and shorten the rod
Extended throttle shafts not required
Part No. 9251S
A competitively priced, 3×2 carburetor linkage with clean, traditional looks, die-cast Superlink levers and a stainless steel link rod.
Use on intake manifolds with carburetors 4-7/8 inches apart. If in doubt, simply measure your manifold spacing – throttle shaft to throttle shaft.
Exclusive to Stromberg Speed Parts, this linkage features ‘Snapback’ throttle return springs which virtually disappear from view. The swivels are positively fixed by a small e-clip on the back, and the small black set-screws on the front have knurled ends for a strong fix on the stainless rod.
The linkage comes pre-assembled, installs in just two simple steps and comes with full instructions. Click the other tabs for help with installation and tuning.
So you’ve got your Stromberg TwoStep 3x2 progressive linkage. Here’s how to make the best use of it. Primary and secondary carbs, banjos, fuel pumps, push or pull? There’s a lot to learn.
TwoStep, linkage, installation, guide, download, Owner’s, manual, instructions, 3×2, 2×2
Download PDF
