TwoStep 3×2 Progressive Linkage. 5-3/16in carb spacing

Overview

Fits Edelbrock 1108 & 1109 3x2 intakes

To use with banjo fittings, add 9086K spacers

Use with Stromberg 9145-59A or 9145-11A fuel line

Extended throttle shafts not required

Part No. 9245PRO

$179.95

Updating Wishlist
179.95

  $

TwoStep 3×2 Progressive Linkage. 5-3/16in carb spacing

A premium 3×2 progressive carburetor linkage designed for optimum performance and versatility. Use on intakes with 5-3/16in carb spacing. If in doubt, simply measure your manifold spacing – throttle shaft to throttle shaft.

Exclusive to Stromberg Speed Parts, this linkage features our ‘Snapback’ throttle return springs which virtually disappear from view. Special swivels and bolts clamp the rod ends tight, yet still allow full rotation. The small bolt has a blind hole, allowing you to insert eg, a hex key, to tighten the lock nut.

The tapered rod stops are fully adjustable, with discreet set screw fixings and opposite threaded rod ends ensure easy adjustment. Just spin the secondary link rod to adjust for the correct lever angles.

The linkage comes pre-assembled, installs in just two simple steps and comes with full instructions. Click the other tabs for help with installation and tuning.

WARNING! To use this linkage with banjo fuel fittings, you must add our 9086K banjo fitting spacers to ensure safe clearance between the long lever and the fuel line. Always read the instructions before installation.

Tech Center

Tuning the 3×2 Progressive linkage

So you’ve got your Stromberg TwoStep 3x2 progressive linkage. Here’s how to make the best use of it. Primary and secondary carbs, banjos, fuel pumps, push or pull? There’s a lot to learn.

Literature

TwoStep Linkage Installation Guide

TwoStep, linkage, installation, guide, download, Owner’s, manual, instructions, 3×2, 2×2

Download PDF