A premium 2×2 carburetor linkage with rod ends for positive action, die-cast Superlink levers and a stainless steel link rod. Use on intake manifolds with carburetors 9-5/8 inches apart. If in doubt, simply measure your manifold spacing – throttle shaft to throttle shaft.

Please note: Photo shows 9242P kit. This kit just  puts the carburetors a little closer together.

Exclusive to Stromberg Speed Parts, this linkage features ‘Snapback’ throttle return springs which virtually disappear from view. Special bolts were developed with a small blind hole, allowing you to insert eg, a hex key, to tighten the lock nut. And opposite threaded rod ends ensure easy adjustment. Just spin the link rod to correct the lever angles.

The linkage comes pre-assembled, installs in just two simple steps and comes with full instructions. Click the other tabs for help with installation and tuning.