This Trim-to-Fit 6×2 direct linkage kit adapts to a wide variety of applications with maximum dimensions as given above. If in doubt, measure your manifold spacing.

The back-bar element comprises unique low-line brackets with rolled ends and Oilite self-lubricating bushes – one long and one short. Trim the long one to suit the offset between the two banks of carbs. Supported at four points for zero flex, the stainless steel back-bar shaft comes with two end stops to prevent lateral movement.

The carburetors are connected through six 9091K Superlink throttle levers with swivels – including two special swivels to mount the rod ends – plus two long link rods. The kit comes with four Stromberg ‘Snapback’ throttle return springs

The connection to your throttle pedal linkage is via one of the two long back-bar levers, or a further one (Stromberg kit 9096K) added anywhere along the back-bar shaft to align with your ‘pull’ point. Stromberg recommends a mechanical pedal link for all multi-carb systems.

The linkage comes pre-assembled with full instructions on trimming, installation and tuning. Click the other tabs to preview.

Designed for maximum versatility in operation, the long back-bar levers have three mounting points for flexible throttle response and leverage. For more information, check out our 6×2 Tuning Tips at the Stromberg Tech Center.

NOTE: This kit will not fit Holley or Edelbrock 94 carburetors as the idle mix screws are on the back where the brackets fit on the 97.