A specially developed 4×2  linkage for the Offenhauser Pacesetter 5024 intake and others with dimensions as given above. If in doubt, measure your manifold spacing.

The back-bar comprises unique low-line brackets with rolled ends and Oilite self-lubricating bushes – one long and one short to suit the offset between the two banks of carbs. Supported at four points for zero flex, the stainless steel back-bar shaft comes with two end stops to prevent lateral movement. Opposite threaded rod ends ensure easy linkage adjustment. Just spin the secondary link rod to adjust for the correct lever angles.

Connects to your throttle pedal linkage via one of the two long back-bar levers, or a further one (Stromberg kit 9096K) added anywhere along the back-bar shaft to align with your ‘pull’ point. Stromberg recommends a mechanical pedal link for all multi-carb systems.

The linkage comes pre-assembled, installs easily and comes with full instructions. Click the other tabs for help with installation and tuning.

Please note: This kit will not fit Holley, Ford or Edelbrock 94-style carburetors which have idle mixture screws on the back.