SuperSeat hose fitting 

The only brass hose end available with the correct 18 degree seat for Stromberg inlet fittings (original or S-jet).

SuperSeat hose fitting - chromed 

The only brass hose end available with the correct 18 degree seat for Stromberg inlet fittings (original or S-jet).

Ford nut compression fittings x 3 

Specialist brass compression fittings with the correct 1/2in x 20 UNF thread for Stromberg inlet valves.

Ford nuts - chromed 

Specialist brass compression fittings with the correct 1/2in x 20 UNF thread for Stromberg inlet valves.

Banjo fitting - single end 

How cool are these! For perfect proportions, we make them from big diameter stainless steel material with a recess lip on each side to hide the gasket and move the bolt head closer to the banjo.

Banjo fitting - single end - fits fuel gauge 

All the benefits of our super-popular single-end banjo fitting, but with an 1/8th NPT hole in the end of the banjo bolt to accept your hot rod fuel pressure gauge.

Banjo fitting - single end. Polished 

The perfect hot rod banjo fitting.

Banjo fitting - double end 

The same as our 9082K single-end banjos, but with hose on both sides.

Banjo fitting - double end - fits fuel gauge 

All the benefits of our super-popular double-end banjo fitting, but with an 1/8th NPT hole in the end of the banjo bolt to accept your hot rod fuel pressure gauge.

Banjo fitting - double end. Polished 

The same as our 9082K-P fully polished single banjos, but with hose on both sides.

Replacement banjo bolt - fits fuel gauge 

If you already have Stromberg banjos (9082K or 9083K) and want to add a fuel pressure gauge to your line, right at the carburetor, this is the bolt for you.

Banjo fitting gaskets (x10) 

A pack of ten Stromberg banjo gaskets. A new material too. The same high-tech nitrile/cellulose mix that we use for our main carburetor gaskets. Fits kits 9082K and 9083K. As with any banjo, you should replace the gaskets whenever you disconnect the fitting from the carburetor. There are two gaskets to each fitting.

Banjo fitting spacer 

If you want to use banjo fittings with your 3x2 progressive linkage, these beautiful, media polished stainless steel spacers are exactly what you need.